引用本文
  • 纪玉利,宋明忠,邱国才,钟琏.中速机连杆工艺研究及夹具设计[J].柴油机,2014,36(3):45-47.    [点击复制]
  •    [点击复制]
【打印本页】 【在线阅读全文】 查看/发表评论下载PDF阅读器关闭

←前一篇|后一篇→

过刊浏览    高级检索

本文已被:浏览 555次   下载 535 本文二维码信息
码上扫一扫!
中速机连杆工艺研究及夹具设计
纪玉利,宋明忠,邱国才,钟琏
0
上海齐耀发动机有限公司,上海201108;七一一研究所,上海201108;上海新中动力机厂,上海200072
摘要:针对某中速机两段式连杆传统加工工艺存在的问题,通过工艺研究和夹具设计对传统加工工艺进行了改进。实际生产表明:改进后的加工工艺不仅使产品满足图纸的技术要求,而且大大提高了生产效率,降低了制造成本,符合批量生产的要求。
关键词:  连杆  加工  工艺  夹具
Machining Technology of Medium-speed ConnectingRod and its Grip Device Design
Ji Yuli,Song Mingzhong,Qiu Guocai,Zhong Lian
Shanghai Qiyao Engine Co., Ltd., Shanghai 201108;Shanghai Marine Diesel Engine Research Institute, Shanghai 201108;Shanghai Xinzhong Power Machine Plant, Shanghai 200072
Abstract:Aimed at the machining of two-section connecting rods for medium-speed engine, through machining technology and grip device design, the traditional machining technology was improved. Manufacturing experiences show that the improved machining technology could not only satisfy the technical requirements of the layout, but also could greatly improve the production efficiency, reduce manufacturing cost, and meet the demand for mass production.
Key words:  connecting rod  machining  technology  grip device〖FL