引用本文
  • 劳贺,李育学.高压共轨缝隙式喷油器喷雾特性的仿真研究[J].柴油机,2012,34(1):22-25.    [点击复制]
  •    [点击复制]
【打印本页】 【在线阅读全文】 查看/发表评论下载PDF阅读器关闭

←前一篇|后一篇→

过刊浏览    高级检索

本文已被:浏览 758次   下载 516 本文二维码信息
码上扫一扫!
高压共轨缝隙式喷油器喷雾特性的仿真研究
劳贺,李育学
0
海军工程大学船舶与动力学院,湖北武汉430033
摘要:在相同流通截面积的条件下,运用AVL-HYDSIM软件计算圆孔式喷嘴燃油的一维流动,并将计算结果作为边界条件,运用AVL-FIRE软件对缝隙式和圆孔式喷嘴的内流场及雾化形态进行了三维仿真计算,并对仿真结果进行对比分析。分析表明:较圆孔式喷嘴,缝隙式喷嘴空穴流强度大,在喷孔出口截面上分布更均匀;缝隙式喷嘴有相对良好的喷雾性能。
关键词:  缝隙式喷油器  雾化特性  仿真
Simulation Study on Spray Characteristics of the High Pressure Common Rail Gapping Injector
Lao He,Li Yu Xue
College of Marine and Power Engineering,Naval University of Engineering,HubeiWuhan430033
Abstract:Based on the same area of currency, the 1-D fuel flow of the round nozzle was calculated with AVL-HYDSIM. The calculation results were used as boundary conditions, and AVL-FIRE software were used to carry out 3-D simulation on the flow fields and atomization quality of the gaping hole nozzles and the round nozzles. The simulation results are compared and analyzed, which show that the cavitation in gapping nozzle is more intensive than the round one\'s, and is better in uniform distribution of cavitation at the nozzle exit section; the atomization quality in the gapping nozzle is better than the round one.
Key words:  gapping injector  spray characteristics  simulation